About regular inspection and maintenance of CNC lathes
1, in the CNC lathe reboot before the need for the machine's circuit boards for artificial preheating, you can also choose to use the electric hair dryer to each circuit board heating for a few minutes, as long as a little bit of temperature can be.
2, regularly for the machine tool to replace the system's battery, for the machine tool electrical cabinet to replace the desiccant, especially in the need to rest for a long period of time before shutting down the machine, must not forget this step!
3, regularly on the hydraulic system in the hydraulic oil pressure, hydraulic pressure and hydraulic impurities to check, so as to ensure the smooth flow of oil.
4, Regularly lubricate or clean the spring-loaded devices such as program switch, knife arm spring and hydraulic valve spring.
5, regularly check the hydraulic system fan, if the fan is contaminated with too much oil, need to clean up in time or to replace, the use of time more than 3a must be replaced.
6, according to the drive equipment contaminated with oil in specific cases, regular cleaning oil.
7, for the use of a longer period of time machine tools, if you take a long vacation, you should try not to shut down the machine, you can put the emergency stop can be photographed.
According to the Measures for the Evaluation of Science and Technology-based Small and Medium-sized Enterprises (Guo Ke Fa Zheng  No. 115), the Circular of the Ministry of Science and Technology and the State Administration of Taxation on Matters Concerning the Evaluation of Science and Technology-based Small and Medium-sized Enterprises (Guo Ke Fa Huo  No. 11), and the Guidelines for Evaluation Services of Science and Technology-based Small and Medium-sized Enterprises (Guo Ke Huo Zi  No. 67), the province was decided to carry out the 2023 evaluation of national science and technology-based small and medium-sized enterprises. It is decided to carry out the evaluation of national science and technology-based small and medium-sized enterprises in the province (except Ningbo, the same hereinafter) in 2023. The relevant matters are hereby notified as follows.
Five-axis milling and boring machining center process characteristics are determined by the production of the power head, mainly for drilling, tapping, boring, chamfering, milling, grinding and other types of processing to meet the processing needs of most customers. The power head is highly applicable and can be easily adjusted for different sized tools of the same type according to the type of tool used. Power head spindle with high rotary accuracy, good rigidity, no mechanical wear and vibration absorption, etc., suitable for cast iron, steel, non-ferrous metal materials, high machining accuracy can be combined with the stroke of the slide table to control the movement process of the power head, to meet the workpiece of a variety of modeling process characteristics. The guide rail and bed of the hard rail are integrated casting parts, and then the guide rail is processed on that basis, and then processed through quenching, grinding and then processed into the guide rail.